EasyManua.ls Logo

Daktronics OMNISPORT 2000 - Lane On;Off; Start

Default Icon
182 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Track Mode Operation
119
While other race information is shown on the right LCD, the left and middle LCDs show
lane status. The table below explains the lane status symbols that may appear during a
race.
Symbol Denition
(blank) Lane is off
-
Timer has been reset
NN
Arming delay (“NN” equals a number from 1-2 that is counting down to 0)
*
Lane armed for a nal time
O
Lane has nished the race
?
There is a problem with the button interface
An example of the three LCDs is shown below. While all possible lane status symbols are
shown, it is unlikely to appear like this during an actual meet.
1 2 3 4 5 6 7 8 9 10
* 2 ? *
Track Keys
The keys highlighted on the Track insert (LL-2573) are grouped together and shaded
by lane. Lane 1 keys line-up vertically with Lane 1 on the LCD, Lane 2 keys with Lane 2,
and so on through Lane 10. The lane keys, along with all other keys on the insert, are
described in the following sections.
Lane On/Off
At the start of a race, the timer automatically turns every lane on. It is up to the operator
to turn lanes off as needed. Use these keys to disable the empty lanes after the start of a
race.
For each lane that is empty (no runner in that lane), press [LANE ON/OFF] to tell the timer
to not expect any data from that lane. A second use of the key is to temporarily disable
a lane and then turn it back on.
Start
The operator has the option to start the timer counting by pressing [START]. The printer
will label the results with the source of the start. If the keypad was used it would be
labeled Source: Keyboard. If the start was from the horn start it would be labeled Source:
External.
Examples when to use Start:
Starting the race
Testing the timing system or scoreboard
Store Print
The [STORE PRINT] key stores the race data for later use and prints the results for
verication. When pressed, the event data is stored up to its current status. It then
performs the printer commands selected in the SETUP-PRINTER menu. To print information
from a previous race, go to the PRINT STORED DATA menu. Refer to Print Menu (p.127)
for more information.
* 1 O *
00:52.5
012 02 LANE

Table of Contents

Other manuals for Daktronics OMNISPORT 2000

Related product manuals