Daktronics OMNISPORT 2000 - Setup Numeric Scoreboard Menu; Setup RTD;Matrix Scoreboard Menu

Diving Mode Operation, Menus, & Settings
76
Lead Diver
This menu determines whether or not the diver with the most
points is displayed.
DISPLAY LEAD
DIVER-YES*
From Main Menu – [4]>[2]>[1]>[2]
Use [↑][↓] to select YES/NO and press [ENTER] to save.
Multisport SB
This menu determines whether or not the display in use at the
facility is a multisport scoreboard.
MULTISPORT
SCOREBOARD- NO*
From Main Menu – [4]>[2]>[1]>[3]
Use [↑][↓] to select YES/NO and press [ENTER] to save.
Setup RTD/Matrix Scoreboard Menu
This menu congures how the console will output Real-Time
Data (RTD) to matrix displays.
RTD Offset
This menu will add an offset to the Real-Time Data (RTD)
output to the matrix display.
MENU-RTD/MATRIX
RTD OFFSET: 5K*
From Main Menu – [4]>[2]>[2]>[1]
Use [↑][↓] to toggle through the RTD offset settings (0K, 5K, 10K, or 15K). Each setting adds
5000 to the original item numbers, up to 15000. The default setting is 0K (no offset).
To save the setting, press [ENTER].
When to use this:
• Data from more than one pool/OmniSport 2000 is going to one display.
• If using a Daktronics M2, M3, or V-Link
®
controlled display, this menu allows multiple
RTD inputs directly into the display.
Setup Comm Ports Menu
The following Comm Ports menus select the protocol used
for transmitting data to the display and communicating with
a results program.
Scoreboard Outputs
Select Scoreboard Outputs to assign a protocol to transmit
data from the J2 and J3 outputs on the console.
MENU-COMM PORTS
SCBD: MULTIDROP*
From Main Menu – [4]>[3]>[1]
MENU-NUMERIC
2-LEAD DIVER
MENU-NUMERIC
3-MULTISPORT SB
MENU-SCOREBOARD
2-RTD/MATRIX
MENU-RTD/MATRIX
1-RTD/OFFSET
From Main Menu – [4]>[2]>[2]
MENU-SETUP
3-COMM PORTS
MENU-COMM PORTS
1-SCBD OUTPUTS
From Main Menu – [4]>[3]