Daktronics OMNISPORT 2000 - Delete Event; Clear Order; Clear Order a (a; Diver Order

Diving Mode Operation, Menus, & Settings
71
When to use this:
• If an event was missed and not programmed into the original event order.
• An additional event was added, like a time trial, and needs to be placed into the
event order.
Delete Event
This menu is used to remove an event from the event order
list.
DELETE INDEX
#001* E:001 R:P
From Main Menu – [2]>[2]>[3]
Use [↓][↑] to select the event location number to be deleted. Press [ENTER] to delete the
location number shown.
When to use this:
• If an extra event was programmed into the original event order.
Clear Order
This menu is used to completely erase the entire event order
stored in the OmniSport 2000 console. Use with caution�
MENU-EVENT ORDER
CLEAR ORDER? Y/N
From Main Menu – [2]>[2]>[4]
Press [YES] to clear the entire event order and exit the menu. Press [NO] to exit the menu
and leave the event order as is.
When to use this:
• If the existing event order needs to be completely erased from memory in the
OmniSport 2000 console so a new event order can be programmed from scratch.
Clear Order A (A-D)
This menu is used to clear one of the four dive orders (A, B, C
or D). The specic dive order to be cleared must be selected
before entering the menu. Refer to Selecting the Order
(p.66).
CLEAR OUT DIVE
ORDER-A Y/N?
From Main Menu – [2]>[3]
Press [YES] to clear the order. Press [NO] to exit the menu and leave the dive order as is.
When to use this:
• Refer to Pre-Event Setup (p.65) and Operation During Event (p.66).
Diver Order
This menu is used to edit the dive orders. The specic dive
order to be edited must be selected before entering the
menu. Refer to Selecting the Order (p.66).
MENU-EVENT ORDER
3-DELETE EVENT
From Main Menu – [2]>[2]>[↓]>[↓]
MENU-EVENT ORDER
4-CLEAR ORDER
From Main Menu – [2]>[2]>[↓]>[↓]>[↓]
MENU-EDIT
3-CLEAR ORDER A
From Main Menu – [2]>[↓]>[↓]
MENU-EDIT
4-DIVER ORDER
From Main Menu – [2]>[↓]>[↓]>[↓]