Track Mode Menus & Settings
132
RESULTS ORDER
ORDER-LANE *
From Main Menu – [4]>[2]>[2]>[3]
RESULTS ORDER
ORDER-PLACE*
Use [←][→] to select either LANE or PLACE and then press [ENTER] to save.
When to use this:
• Select LANE to display the results in the order of the lane in which the runners nished.
• Select PLACE to display the results in the order of which the runners placed.
Show DQ
This menu congures what will show on the display when
there is a disqualication (DQ).
SHOW DQ
STATUS=DQ ONLY*
From Main Menu – [4]>[2]>[2]>[4]
SHOW DQ
STATUS=DQ/TIME*
Use [←][→] to select to display the DQ ONLY (in the TIME eld) or to display the DQ/TIME,
with “DQ” in the PLACE eld and the time in the TIME eld. Press [ENTER] to save.
RTD Offset
This menu will add an offset to the Real-Time Data (RTD)
output to the matrix display.
MENU-RTD/MATRIX
RTD OFFSET: 5K*
From Main Menu – [4]>[2]>[2]>[5]
Use [↑][↓] to toggle through the RTD offset settings (0K, 5K, 10K, or 15K). Each setting adds
5000 to the original item numbers, up to 15000. The default setting is 0K (no offset).
To save the setting, press [ENTER].
When to use this:
• Data from more than one pool/OmniSport 2000 is going to one display.
• If using a Daktronics M2, M3, or V-Link
®
controlled display, this menu allows multiple
RTD inputs directly into the display.
Setup Comm Ports Menu
The following Comm Ports menus select the protocol used
for transmitting data to the display and communicating with
a results program.
Scoreboard Outputs
Select Scoreboard Outputs to assign a protocol to transmit
data from the J2 and J3 outputs on the console.
MENU-COMM PORTS
SCBD: MULTIDROP*
From Main Menu – [4]>[3]>[1]
Use [←][→] to select MULTIDROP, MULTILINE, or OMEGA protocol, depending on the type
of display used, and then press [ENTER] to save. MULTICAST is reserved for future use.
MENU-RTD/MATRIX
4-SHOW DQ
MENU-RTD/MATRIX
5-RTD/OFFSET
MENU-SETUP
3-COMM PORTS
MENU-COMM PORTS
1-SCBD OUTPUTS
From Main Menu – [4]>[3]
To Next Page
Loading...
