Daktronics OMNISPORT 2000 - Setup Timer Menu

Track Mode Menus & Settings
128
Press [YES] to print the selected results (Figure 63). Press [NO] to ignore the selection and
return to the Print Menu.
If the desired race has been deleted from the console’s memory, the LCD will ash RACE
NOT FOUND.
PRINT RESULTS
RACE NOT FOUND
When to use this:
• Use this to re-print a race result on the console’s built-in thermal printer.
Print Settings
This menu is used to print the console’s conguration.
MENU-PRINT
PRINT SETTINGS?
From Main Menu – [3]>[2]
Press [YES] to print the settings. Press [NO] to exit the menu without printing.
When to use this:
• Print the settings after the console has been set up and functioning correctly. Keep
this printout for future reference. It will be valuable if the console is loaned out to
someone else, a change was made in the console unknowingly, or if the console was
returned to or exchanged by Daktronics for service.
• It is a good idea to pull out the known good settings and verify them to a new
printout when the equipment is being set up for a meet.
Setup Timer Menu
This menu congures the track settings.
Number of Lanes
This setting tells the OmniSport 2000 console how many lanes
are on the track.
MENU-TIMER
# OF LANES: ^8*
From Main Menu – [4]>[1]>[1]
Press the [0]–[9] keys to enter the number of lanes from 1 to 10. When the correct number
of lanes is shown on the LCD, press [ENTER] to save.
Start Input
The console can be congured to receive inputs from
different starting devices. Some start devices are an open
switch that closes (Normally Open) and others are a closed
switch that opens (Normally Closed).
MENU-TIMER
START IN: N.O.*
From Main Menu – [4]>[1]>[2]
MENU-PRINT
2-SETTINGS
MENU-SETUP
1-TIMER
From Main Menu – [4]
MENU-TIMER
1-# OF LANES
From Main Menu – [4]>[1]
MENU-TIMER
2-START IN