DataCard CR805 - Page 47

CR805 Retransfer Card Printer Installation and Administrator’s Guide 31
d. Press E
NTER to enter the Configuration menu.
e. Press the down arrow to display Network IPv4 on line 2.
f. Press E
NTER to enter the Network IPv4 menu. DHCP/
Static IP displays on line 2.
3. Press E
NTER to display the DHCP/Static IP menu. Static IP
displays on line 2.
4. Set the static IP address, subnet mask, and gateway address.
a. Press E
NTER to enter the Static IP menu. IP Address
displays on line 2.
b. Press E
NTER to set the static IP address.
The IP address has four sections, separated by periods. A
cursor appears under the digit that will change.
i. Use the arrow keys to change one digit at a time.
ii. The address section shows three digits when it can
be changed and the cursor is under the right-most
digit. Press E
NTER to navigate to the next section of
the address.
iii. When all four sections are correct, press E
NTER.
Subnet Mask displays on line 2 of the LCD panel.
c. Repeat step b, i through iii, to enter the subnet
mask and gateway address.