EasyManuals Logo

DataCard CR805 Installation And Administrator's Guide

DataCard CR805
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
CR805 Retransfer Card Printer Installation and Administrator’s Guide 71
 EthAddressMethod—The method used to obtain the IPv4 network IP address. Select DHCP
or STATIC from the Current Value drop-down list.
 When the value is DHCP, the EthGatewayAddress, EthIpAddress, and EthSubnetMask
values are controlled by the DNS server and the settings are filled in automatically.
 When the value is STATIC, the EthGatewayAddress, EthIPAddress, and EthSubnetMask
values must be set manually.
 EthGatewayAddress—Enter the gateway address for the Ethernet network.
 EthIpAddress—Enter the static IP address for the printer.
 EthSubnetMask—Enter the subnet mask for the Ethernet network.
 EthDnsAddress1, EthDnsAddress2, EthDnsSearchSuffix—These settings are not used at this
time.
 IPMode—Specify the IP mode used by the printer. The printer can support both IPv4 and
IPv6 addressing. You can select from the following:
 IPv4—The printer uses IPv4 addressing only.
 DualStack—The printer can use both IPv4 and IPv6 addressing.
The remaining IPv6 settings become applicable when IPMode is set to DualStack.
 IPv6DefaultGateway—Set a default gateway address. This setting is disabled when set to the
default of “::”.
 IPv6DHCPv6Select—Select whether or not the printer obtains an address and stateful
configuration from a DHCPv6 server. Disable this setting if a DHCPv6 server is not present.
 IPv6DNSPrimaryAddress, IPv6DNSSecondaryAddress—These settings are not used at this
time.
 IPv6ManualAddress—Enter the IPv6 address using the following format:
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
Refer to Access Printer Manager on page 60 for more information about entering an IPv6
address.
IPV6ManualSelect must be set to Enabled for the printer to use this setting.
 IPv6ManualPrefixLength—Specify the IPv6 manual subnet prefix length. IPv6 addresses
consist of two parts. The prefix length indicates the boundary between the subnet to which
the host is connected and device ID in the IPv6 manual address, starting from the left end.
The default value is 64.

Table of Contents

Other manuals for DataCard CR805

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DataCard CR805 and is the answer not in the manual?

DataCard CR805 Specifications

General IconGeneral
BrandDataCard
ModelCR805
CategoryPrinter
LanguageEnglish

Related product manuals