DataCard CR805 Installation And Administrator's Guide

72 Printer Manager
 IPv6ManualSelect—Enable the printer to use the manual address specified in
IPv6ManualAddress. If this setting is disabled, the manual address information specified for
the printer is retained, but is not used.
 IPv6StatelessAddrSelect—Enable the printer to allow the router to provide one or more
network prefixes used for stateless automatic address configuration (SLAAC).
 SecurityTlsTrustStoreServerAuth—Specify which trusted certification authority (CA)
certificates to apply for authenticating the TLS server certificate. You can select from the
following options:
 BuiltInOnly: Trust only the built-in list of Entrust-trusted CA certificates as trust anchors
when performing server authentication. Certificate validation is always checked and
access is denied on failure. If not all the built-in certificates are trusted, you can pick the
ones you trust and add them to the custom set (select CustomOnly).
 CustomOnly: Trust only the custom list of CA certificates as trust anchors during
certificate validation. If no custom list is installed, accept any certificate without
performing any certificate validation.
 BuiltInAndCustom: Trust both the built-in list and custom list of CA certificates as trust
anchors during certificate validation of the server.
 NoAuthCheck: No authorization is performed.
To modify the Communications settings:
1. Enter your changes in the Current Value fields.
2. Click Set Current to apply the changes.
3. Log out of Printer Manager, and then restart it for the changes to take effect.

DataCard CR805 Specifications

General

Brand	DataCard
Model	CR805
Category	Printer
Language	English