Datalogic Matrix 300

MATRIX 300™ REFERENCE MANUAL
16
1
7. Now place a single application specific code in front of the reader (at the same reading
distance) and repeat steps 3, and 4. Do not perform step 5 "Fine Focusing".
8. Select a Code Setting Mode choice and press the "Code Setting" button.
The Setup Result section of the Setup Wizard window shows the code type results.
NOTE: The Grade A Barcode Test Chart cannot be used to set the Code
128 symbology (even though the reader successfully reads the code). Use
the application specific code if you need to set this symbology.
Setup Result
3
4
8