104
Step Displayed
Message
Operator Action Comments
3. H4210.173
7/01/2005
The printer has automatically reset.
4. READY
The new application is now running.
Note:
If ‘Uncalibrated’ is displayed,
the printer must be calibrated.
Notes:
If the procedure above fails to put the printer into boot mode, use this method:
(A) Turn OFF the power switch.
(B) Press and hold the FEED and CANCEL Keys (the middle and right-hand keys on
the front panel).
(C) Turn ON the printer. After SEND MESSAGE is displayed, release the buttons and
retry the update as described above.
To Next Page
Loading...
