106
Displayed
Message
Description, Possible Causes and Solutions
SYSTEM FAULT
Insufficient memory space for font file exists in the destination module.
Try selecting a different destination module and perform the download
again.
ACCESS
DENIED
FILE EXISTS
A font file of the same name already exists in memory.
ACCESS
DENIED
SOFTWARE
MISMATCH
The software level being installed is not authorized for this printer, the font
bit is still locked, or there is an encryption key revision mismatch. See the
Printer Key information.
WRITING FLASH
The font file was successfully decrypted, verified, and is now being written
into the destination module.
WRITING FLASH
FAILED
The font file failed to verify after being written to a module. Try the
download again; however, if the problem continues call for service.
SUCCESSFUL
The font file was successfully installed; the printer will perform an
automatic reset.
To Next Page
Loading...
