111
Displayed
Message
Description Cause(s)
READY
This is the normal
operating mode of the
printer.
The printer is waiting, ready to receive label
formats, downloads, etc.
REMOVE
RIBBON
PRESS ANY KEY
In order to proceed,
ribbon must be removed
and then a key pressed.
The TEST Button was pressed and held or
CLEAN HEAD NOW was selected with ribbon
installed in the printer.
SAVE
CHANGES?
Changes require
confirmation before
exiting the menu.
The printer is waiting for you to press YES to
proceed with these changes or NO to revert to
the previously saved settings.
Note:
If changes have been made that require a
reset, it will automatically be invoked.
SUCCESSFUL
PRESS ANY KEY
The operation was
successfully executed,
but a key must be
pressed to continue.
The TEST Button was pressed and held or
CLEAN HEAD NOW was selected.
SYSTEM
INITIALIZING
The power switch has
been switched into the
ON position, or a soft
reset has occurred.
This message occurs during a power-up or soft
reset condition (following a SYSTEM RESET
IN PROGRESS message).
SYSTEM RESET
IN PROGRESS
The printer is resetting.
The printer has been reset via the host system
or through the User Interface.
UNCALIBRATED
The printer is not
calibrated.
Calibration must be performed.
WAITING FOR
DATA
A printer is waiting to
receive data.
The GPIO option has been enabled; a Start of
Print signal has been received; and, the printer
awaits label data from the host to proceed.
WAITING FOR
SIGNAL
A label is waiting to be
printed.
The GPIO option has been enabled and the
printer awaits the Start of Print signal to be
supplied from the GPIO card to proceed.
XXXX OF XXXX
PRINTING
A batch print job is in
process.
The printer is updating the printing status --
showing beginning batch total (represented by
the first XXXX number) and the remaining label
count (represented by the second XXXX
number).
To Next Page
Loading...
