63
COLUMN
EMULATION
Allows the dots per inch in the column to be adjusted (153 - 203 dots), so that
numbers smaller than the printhead resolution shrink the image from right to
left, where:
203 Dots Is the Default Setting.
ROW
EMULATION
Allows the number of dots per inch in the row to be adjusted (103 - 303), so
that numbers smaller than the printhead resolution enlarge the height of the
printed output and numbers larger shrink it, where:
203 Dots Is the Default Setting.
SOP
EMULATION
Allows positioning commands to function with backward compatibility when
printing label formats designed for legacy printers, where:
DISABLED Produces the natural start of print position. (Default Setting)
110
(PRODPLUS)
Emulates the Prodigy Plus® start of print position.
220
(ALLEGRO)
Emulates the Allegro® start of print position.
250
(PRODIGY)
Emulates the Prodigy™ start of print position.
Note:
When changing these values, the printer will automatically feed two labels to setup
the new print position.
BACK AFTER
PRINT
Determines the timing of the label's movement when a cutter, present sensor,
peel and present, or GPIO option is enabled, where:
ENABLED Immediate label back-up occurs after the cut operation, when the present
sensor is cleared, or upon receipt of the GPIO start of print signal for fastest
throughput.
DISABLED Label back-up is initiated when the next label is ready to print to help prevent
edge curling. (Default Setting)
BACKUP
DELAY (1/50s)
Instructs the printer to retract a presented label after a specified time delay
elapses (0 – 255, in one-fiftieth of a second increments), where:
000 Retraction only occurs when the next label is received and processed to print.
(Default Setting)
FONT
EMULATION
Allows font substitution for all internal fonts (see examples), where:
STANDARD
FONTS
Prints using standard available fonts. (Default Setting)
CG TIMES Prints using CG Times fonts only.
USER ID
S50
Prints using downloaded fonts only.
To Next Page
Loading...
