68
PARITY
Sets word parity, where:
NONE Parity is not used. (Default Setting)
ODD Odd parity is used.
EVEN Even parity is used.
DATA BITS
Sets word length, where:
7 A seven bit word is used.
8 An eight bit word is used. (Default Setting)
STOP BITS
Sets the number of stop bits, where:
1 One stop bit is used. (Default Setting)
2 Two stop bits are used.
PARALLEL PORT A
Controls the communication setting for the parallel port, where:
PORT DIRECTION
Determines if data is returned from the printer:
UNI-DIRECTIONAL No data is sent from the printer; the communication is one-way.
BI-DIRECTIONAL Data is sent from the printer in compliance with IEEE 1284 back-
channel operation. (Default Setting)
Note:
An IEEE 1284 bidirectional cable must be used when this
mode is selected.
NIC ADAPTER
Controls the communications settings for the network interface, as
follows:
IP ADDRESS
Specifies the static IP Address of the interface in the standard dotted-
decimal format, for example: 010.001.001.130.
SUBNET MASK
Specifies the static Subnet assigned to the interface, for example:
255.255.255.000.
GATEWAY
Specifies the Gateway Address the interface will use, for example:
010.001.001.001.
SNMPTRAP
DESTINATION
Specifies the network IP Address where SNMP traps will be sent when
SNMP service is installed on your receiver. If zeroed, no traps are sent.
To Next Page
Loading...
