Name: Datamax I-Class Mark II
Brand: Datamax
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Firmware (Software) Agreement:

The enclosed Firmware (Software) resident in the Printer is owned by Licensor or its suppliers and is licensed for use

only on a single printer in the user’s Trade or Business. The User agrees not to, and not to authorize or permit

any other person or party to duplicate, or copy the Firmware or the information contained in the non-

volatile or programmable memory. The firmware (Software) is protected by applicable copyright laws and Licensor

retains all rights not expressly granted. In no event will Licensor or its suppliers be liable for any damages or loss,

including direct, incidental, economic, special, or consequential damages, arising out of the use or inability to use the

Firmware (Software).

WARNING

Lithium Battery: There is a danger of explosion or fire if the battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer. Discard used

batteries according to the manufacturer’s instructions.

Information in this document is subject to change without notice and does not represent a commitment on the part of

Datamax-O’Neil. No part of this manual may be reproduced or transmitted in any form or by any means, for any

purpose other than the purchaser's personal use, without the expressed written permission of Datamax-O’Neil.

Part Number 88-2361-01 Rev. A

Other manuals for Datamax I-Class Mark II

Questions and Answers:

Need help?

Do you have a question about the Datamax I-Class Mark II and is the answer not in the manual?

General