Name: Datamax I-Class Mark II
Brand: Datamax
Rating: 4 (1 reviews)

To Next Page

To Previous Page

I-Class Mark II Maintenance Manual

ustments and Maintenance

2.5.1 Loading Boot 1 and Boot 2 and Firmware

1) Connect the printer to your PC using a serial cable.

2) Launch the NETira CT configuration utility, and query (connect) to the printer, (see the Operator’s Manual

for more information on NETira CT).



It is recommended that the configuration be saved before downloading firmware, and restored

when finished. Be sure to check the box labeled “Include Sensor Calibration Data on Open”

when restoring the configuration.

Go to the Tools>Upgrade>Firmware. Select the binary files (BIN files) for each of the Boot files.

4) Check the “Select and Download Boot 1 file:”, “Select and Download Boot 2 file:” and “Erase System

and/or User Area” boxes and click send to initiate the download.



Be sure only that only one communication cable is connected to the printer before attempting

the firmware upgrade. Do not attempt to send any other data or perform operations via the

front panel when the firmware is downloading.



Always Check “Erase System and/or User Area” box unless otherwise instructed.

5) Once the Boot Loader files have been loaded, the firmware version can now be updated using the

procedure outlined in section 2.5.

Other manuals for Datamax I-Class Mark II

Questions and Answers:

Need help?

Do you have a question about the Datamax I-Class Mark II and is the answer not in the manual?

General