Datamax I-Class Mark II Maintenance Manual

47
I-Class Mark II Maintenance Manual Removal and Replacement
4.4 Platen
Removal:
1. Turn OFF and unplug the printer.
2. Raise the cover and remove the Tearplate Fascia, Thumbscrew, and Tearplate.
3. Remove the Gear Cover by pulling the far side out then away from the Centerplate.
 Note: If necessary, loosen the Front Panel Fascia to facilitate removal; see Section 4.2.
Tearplate
Tearplate Fascia
Thumbscrew
Gear Cover

Datamax I-Class Mark II Specifications

General

Power Supply	100-240 VAC, 50-60 Hz
Print Resolution	203 dpi
Print Width	4.09 inches
Memory	16 MB DRAM, 8 MB Flash
Connectivity	USB, Serial, Ethernet
Media Handling	Roll-fed
Media Width	1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness	0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width	1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length	1968 feet (600 meters)
Print Speed	up to 12 ips
Dimensions	12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)