Datamax I-Class Mark II Maintenance Manual

61
I-Class Mark II Maintenance Manual Removal and Replacement
Replacement:
1. Position the Power Supply PCB in the printer then secure it with the four Screws.
2. Place the Washer onto the Screw, and then secure the Ground Wire Lug to the chassis with the Screw.
3. Position the Nut Plate over the AC Connector and then secure the AC Connector and the Nut Plate to the
chassis with the two Screws.
4. Reconnect the cables to the Power Supply PCB.
5. Verify the correct Printhead supply voltage; see Section 2.2.4.

Datamax I-Class Mark II Specifications

General

Power Supply	100-240 VAC, 50-60 Hz
Print Resolution	203 dpi
Print Width	4.09 inches
Memory	16 MB DRAM, 8 MB Flash
Connectivity	USB, Serial, Ethernet
Media Handling	Roll-fed
Media Width	1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness	0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width	1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length	1968 feet (600 meters)
Print Speed	up to 12 ips
Dimensions	12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)