63
I-Class Mark II Maintenance Manual
Removal and Replacement
Replacement:
1. Depending upon the resolution of the printer, position the Isolator against the Centerplate Standoffs then
secure it with the two Screws.
Centerplate Standoffs
(203 DPI)
Centerplate Standoffs
(300 / 600 DPI)
Screws
Isolator
Screws
Isolator
2. Position the Drive Motor against the Isolator.
3. Place the Ground Cable Lug onto one Screw then secure the Drive Motor to the Isolator with the two
Screws.
4. Reconnect the motor cable to the Drive Motor.
5. Reinstall the Cover Assembly; see Section 4.1.
To Next Page
Loading...
