Datasat LS10 - Page 100

LS10 Installation and Operating Guide Version 1.01
Appendix E. LS10 Remote Command API E-3 Document #: 9301H66300 Ver. 1.01
Input Selection Commands
1. Input Selection
Command: @INPUT<space>[input]<CR>
Operation
Response: INPUT<space>input<CR>
Read/Write
This is used to select a new input, or view the current input.
Parameters
input Identifies the desired or selected input name. For the set command to be
successful, the name must be one of the input names:
Stereo 1 Stereo 2 USB
TosLink 1 TosLink 2 SPDIF 1 SPDIF 2
HDMI 1 HDMI 2 HDMI 3 HDMI 4
HDMI 5 HDMI 6 HDMI 7 HDMI 8
Note: Names with a space must use exactly one space.
Upper/lower cases in the name must be followed.
Example
Set the Input to Stereo 1
Send: @INPUT Stereo 1<cr>
Receive: INPUT Stereo 1<cr>
2. EQ Selection
Command: @EQSET<space>[eq]<CR>
Operation
Response: EQSET <space>eq<CR>
Read/Write
This is used to select a new EQ set, or view the current EQ set.
Parameters
eq
EQ1 or EQ2.
Example
Select EQ2
Send: @EQSET EQ2<cr>
Receive: EQSET EQ2<cr>