LS10 Installation and Operating Guide Page 77
LS10 Installation & Operating Guide Document # 9301H66300 Ver. 1.01
3.21.3 Edit Event
To edit an existing event, highlight the event on the list and select Edit Event. This will bring up the
Automation Edit Event screen. Editing choices are the same as those described above in 3.21.1 Add
New Event.
3.22 Automation Serial Setup
The LS10 can be configured to allow an external device to send an RS232 command to the LS10. When
the LS10 receives the specified serial command, it will then execute any predefined action or macro.
From the Setup Home screen, select Automation Serial.
• The baud rate and number of Data Bits must be set in the Automation Serial Setup screen
to match the settings used by the external RS232 device.
• The RS232 device must be connected to the Serial Control port on the back of the LS10.
Figure 58. Automation Serial Setup
• Select the correct Baud Rate from the dropdown list.
• Select the Data Bits: 7 or 8, from the dropdown.
3.23 HDMI Outputs to Different Devices
When HDMI outputs are connected to different display devices, the video image is displayed on both. The
HDMI interface on the LS10 does not perform any video conversion. The same video resolution will be
used on both outputs.
If the player (HDMI input to the LS10) is set to Auto-Select the Resolution, then the resolution of the
image is negotiated between the player and the display devices. It will be set to the highest resolution that
is supported by both display devices. If the display device on output 1 supports up to 1080p and the
highest resolution on display device for output 2 is 720p, then the player will select to play at 720p, and
that resolution is used on both HDMI outputs on the LS10. Some players can be configured to output at a
specific resolution and, in that case, the selected resolution will be used on both HDMI outputs.
To Next Page
Loading...