7.2.42 Register file: 0x29 – Reserved
Reserved – this register file is reserved
Register file: 0x29 – Reserved is reserved. Please take care not to write to this register as doing so may cause
the DW1000 to malfunction.
7.2.43 Register file: 0x2A – Transmitter Calibration block
Transmitter calibration block
Register map register file 0x2A is the transmit calibration block concerned with ensuring the optimum
configuration of the transmit signal. It contains a number of sub-registers. An overview of these is given by
Table 39. Each of these sub-registers is separately described in the sub-sections below.
Table 39: Register file: 0x2A – Transmitter Calibration block overview
Transmitter Calibration – SAR control
Transmitter Calibration – Latest SAR readings
Transmitter Calibration – SAR readings at last Wake-Up
Transmitter Calibration – Pulse Generator Control
Transmitter Calibration – Pulse Generator Status
Transmitter Calibration – Pulse Generator Delay
Transmitter Calibration – Pulse Generator Test
7.2.43.1 Sub-Register 0x2A:00 – TC_SARC
Transmitter Calibration – SAR control
Register file: 0x2A – Transmitter Calibration block, sub-register 0x00, contains the following bitmapped sub-
fields:
REG:2A:00 – TC_SARC – Transmitter Calibration SAR control
To Next Page
Loading...