Dell Force10 TeraScale E Series - Page 1036

1036 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Example
Figure 38-4. Command Example: router ospf
Usage
Information
You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure
OSPF.
Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in
the system.
show config
c e s
Display the non-default values in the current OSPF configuration.
Syntax
show config
Command Modes
ROUTER OSPF
Command
History
Example
Figure 38-5. Command Example: show config
show ip ospf
c e s
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
vrf name
E-Series Only: Show only the OSPF information tied to the VRF process.
Version 7.9.1.0 Introduced VRF
Version 7.9.1.0 Introduced VRF
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.8.1.0
Introduced
process-id option, in support of Multi-Process OSPF.