SNMP and Syslog | 1355
54
SNMP and Syslog
Overview
This chapter contains commands to configure and monitor SNMP v1/v2/v3 and Syslog. Both features
are supported on the C-Series, E-Series, and S-Series platforms, as indicated by the following symbols
under each of the command headings: c e s
The chapter contains the following sections:
• SNMP Commands
• Syslog Commands
SNMP Commands
The SNMP commands available in FTOS are:
• show snmp
• show snmp engineID
• show snmp group
• show snmp user
• snmp ifmib ifalias long
• snmp-server community
• snmp-server contact
• snmp-server enable traps
• snmp-server engineID
• snmp-server group
• snmp-server host
• snmp-server location
• snmp-server packetsize
• snmp-server trap-source
• snmp-server user
• snmp-server view
• snmp trap link-status
The Simple Network Management Protocol (SNMP) is used to communicate management information
between the network management stations and the agents in the network elements. FTOS supports
SNMP versions 1, 2c, and 3, supporting both read-only and read-write modes. FTOS sends SNMP
traps, which are messages informing an SNMP management system about the network. FTOS supports
up to 16 SNMP trap receivers.
To Next Page
Loading...
