Dell Force10 TeraScale E Series - Page 1361

SNMP and Syslog | 1361
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
snmp-server enable traps
c e s
Enable and configure SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-option]
command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
notification-type
Enter the type of notification from the list below:
•
bgp—Notification of changes in BGP process
•
envmon—For Dell Force10, device notifications when an environmental
threshold is exceeded
•
snmp—Notification of RFC 1157 traps.
•
stp —Notification of state change in Spanning Tree protocol (RFC 1493)
•
vrrp—Notification of state change in a VRRP group
•
xstp—Notification of state change in MSTP (802.1s), RSTP (802.1w), and
PVST+
notification-option For the envmon notification-type, enter one of the following optional
parameters:
• fan
• supply
• temperature
For the
snmp notification-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Version 8.4.2.5 New format for VRRP traps was introduced on the C-Series. New STP, RSTP, and
PVST+ traps for root and topology changes were added on the C-Series.
Version 8.4.1.3 New format for VRRP traps was introduced on the E-Series ExaScale. New STP, RSTP,
and PVST+ traps for root and topology changes were added on the E-Series ExaScale.
Version 8.4.1.0 Support was added for VRRP traps.
Version 7.6.1.0 Support added for S-Series; Added support for STP and xSTP traps.