Dell Force10 TeraScale E Series - BOOT_USER Mode; Overview; Commands

BOOT_USER Mode | 59
4
BOOT_USER Mode
Overview
Most of the commands in this chapter are in Configuration mode, except for format, which is in the
BOOT_ADMIN mode. The exception to this is that on the Dell Force10 S50 platform. On the S50, the
commands are accessed from the BOOT_USER mode. Command support on Dell Force10 platforms is
indicated by the characters that appear below each command heading:
•
c = C-Series
• e = E-Series
• s = S-Series
To access the BOOT_USER mode, boot your Dell Force10 platform.When the prompt, “Hit any key
to break into BOOT_USER mode” appears, press a key.
Commands
• boot change
• boot messages
• boot selection
• boot zero
• default-gateway
• delete
• dir
• enable
• format
• ignore enable-password
• ignore startup-config
• interface management ethernet ip address
• interface management ethernet mac-address
• interface management ethernet port
• interface management port config
• reload
• rename
• restore factory-defaults
• save
• show boot selection
• show bootflash