Dell Force10 TeraScale E Series - Page 69

BOOT_USER Mode | 69
Parameters
Defaults
None.
Command Modes
BOOT_USER
restore factory-defaults
s
Erase all NVRAM sectors, EEPROM sectors, and user boot configurations.
Syntax
restore factory-defaults
Command Modes
BOOT_USER
Command
History
save
s
Save configurations created in BOOT_USER mode (BLI).
Command
History
Usage
Information
A basic difference between S-Series and other Dell Force10 platforms is that, on the S-Series, FTOS
does not save configurations into NVRAM while the user enters them in the BLI. Instead, the
configurations are saved in a software cache and are written into NVRAM only on the execution of this
save command or of the reload command.
Related
Commands
show boot selection
c e
Display the current FTOS boot image.
Syntax
show boot selection
Command Modes
BOOT_USER
file-url
Enter the location keywords and information:
• For a file on the internal Flash, enter
flash:// followed by the filename.
• For a file on the external Flash, enter
slot0:// followed by the filename.
Version 7.8.1.0 Introduced on S-Series
Version 7.8.1.0 Introduced on S-Series
reload
Exit from this mode and reload FTOS.
write
Save the running configuration to the startup configuration file.