Dell Force10 TeraScale E Series - PIM-Dense Mode (PIM-DM); Overview; IPv4 PIM-Dense Mode Commands

PIM-Dense Mode (PIM-DM) | 1095
40
PIM-Dense Mode (PIM-DM)
Overview
PIM-DM is supported on E-Series ExaScale e
x
in FTOS 8.1.1.0. and later.
PIM-DM is supported on E-Series TeraScale e
t
, C-Series c, and S-Series s platforms in FTOS
8.4.2.0. and later.
For information on the commands required to configure and use PIM-Dense Mode (PIM-DM), refer to:
• IPv4 PIM Commands on page 1131
• IPv4 PIM-Dense Mode Commands
IPv4 PIM-Dense Mode Commands
The IPv4 PIM-Dense Mode (PIM-DM) commands are:
• ip pim dense-mode