Dell Force10 TeraScale E Series - PIM-Sparse Mode (PIM-SM); Overview; IPv4 PIM-Sparse Mode Commands

PIM-Sparse Mode (PIM-SM) | 1097
41
PIM-Sparse Mode (PIM-SM)
Overview
The platforms on which a command is supported is indicated by the character — e for the E-Series,
c for the C-Series, and s for the S-Series — that appears below each command heading.
PIM is supported on E-Series ExaScale e
x
with FTOS 8.1.1.0. and later.
This chapter contains the following sections:
• IPv4 PIM-Sparse Mode Commands
• IPv6 PIM-Sparse Mode Commands
IPv4 PIM-Sparse Mode Commands
The IPv4 PIM-Sparse Mode (PIM-SM) commands are:
• clear ip pim rp-mapping
• clear ip pim tib
• clear ip pim snooping tib
• debug ip pim
• ip pim bsr-border
• ip pim bsr-candidate
• ip pim dr-priority
• ip pim graceful-restart
• ip pim join-filter
• ip pim ingress-interface-map
• ip pim neighbor-filter
• ip pim query-interval
• ip pim register-filter
• ip pim rp-address
• ip pim rp-candidate
• ip pim snooping
• ip pim sparse-mode
• ip pim sparse-mode sg-expiry-timer
• ip pim spt-threshold
• no ip pim snooping dr-flood
• show ip pim bsr-router