Dell Force10 TeraScale E Series - Queue-Level Debugging

1224 | Quality of Service (QoS)
www.dell.com | support.dell.com
Command
History
Usage
Information
Use the default pre-defined profiles or configure your own profile. You can not delete the pre-defined
profiles or their default values. This command enables the WRED configuration mode—(conf-wred).
Related
Commands
Queue-Level Debugging
Queue-Level Debugging is an E-Series-only feature, as indicated by the e character that appears
below each command heading.
The following queuing statistics are available on both the EtherScale and TeraScale versions of
E-Series systems.
• clear queue statistics egress
• clear queue statistics ingress
• show queue statistics egress
• show queue statistics ingress
clear queue statistics egress
e
Clear egress queue statistics.
Syntax
clear queue statistics egress [unicast | multicast] [Interface]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
pre-Version 6.1.1.1 Introduced on E-Series
threshold Specify the minimum and maximum threshold values of the WRED profile
unicast | multicast (OPTIONAL) Enter the keyword multicast to clear only Multicast queue
statistics. Enter the keyword
unicast to clear only Unicast queue statistics.
Default: Both Unicast and Multicast queue statistics are cleared.
Interface
(OPTIONAL) Enter one of the following interfaces to display the interface
specific queue statistics.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• Fast Ethernet
is not supported
Version 6.2.1.1 Introduced