PIM-Source Specific Mode (PIM-SSM) | 1131
42
PIM-Source Specific Mode (PIM-SSM)
Overview
The platforms on which a command is supported is indicated by the character — e for the E-Series,
c for the C-Series, and s for the S-Series — that appears below each command heading.
PIM is supported on E-Series ExaScale e
x
with FTOS 8.1.1.0. and later.
This chapter contains the following sections:
• IPv4 PIM Commands
• IPv4 PIM-Source Specific Mode Commands
• IPv6 PIM Commands
• IPv6 PIM-Source Specific Mode Commands
IPv4 PIM Commands
The following commands apply to IPv4 PIM-SM, PIM-SSM, and PIM-DM:
• clear ip pim tib
• debug ip pim
• ip pim dr-priority
• ip pim graceful-restart
• ip pim neighbor-filter
• ip pim query-interval
• show ip pim interface
• show ip pim neighbor
• show ip pim tib
IPv4 PIM-Source Specific Mode Commands
The IPv4 PIM-Source Specific Mode (PIM-SSM) commands are:
• ip pim ssm-range
• ip pim join-filter
• show ip pim ssm-range
To Next Page