Dell Force10 TeraScale E Series - Per-Port QoS Commands

1180 | Quality of Service (QoS)
www.dell.com | support.dell.com
Per-Port QoS Commands
Per-port QoS (“port-based QoS”) allows users to defined QoS configuration on a per-physical-port
basis. The commands include:
• dot1p-priority
• rate limit
• rate police
• rate shape
• service-class dynamic dot1p
• show interfaces rate
• strict-priority queue
dot1p-priority
c e s
Assign a value to the IEEE 802.1p bits on the traffic received by this interface.
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, enter no dot1p-priority.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE
Command
History
priority-value
Enter a value from 0 to 7.
dot1p Queue Number
02
10
21
33
44
55
66
77
For the C-Series and S-Series, enter a value 0, 2, 4, or 6
dot1p Queue Number
01
10
20
31
42
52
63
73
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series