Layer 2 | 867
30
Layer 2
Overview
This chapter describes commands to configure Layer 2 features. It contains the following sections:
• MAC Addressing Commands
• Virtual LAN (VLAN) Commands
Some MAC addressing commands are supported only on the E-Series, some on all three Dell Force10
platforms and some on two Dell Force10 platforms. Support is indicated by these characters, where
appropriate, under each command heading:
c e s
The VLAN commands are supported on all three Dell Force10 platforms — c e s
MAC Addressing Commands
The following commands are related to configuring, managing, and viewing MAC addresses:
• clear mac-address-table dynamic
• mac accounting destination
• mac-address-table aging-time
• mac-address-table static
• mac-address-table station-move threshold
• mac-address-table station-move time-interval
• mac-address-table station-move refresh-arp
• mac cam fib-partition
• mac learning-limit
• mac learning-limit learn-limit-violation
• mac learning-limit station-move-violation
• mac learning-limit reset
• show cam mac linecard (count)
• show cam maccheck linecard
• show cam mac linecard (dynamic or static)
• show cam mac stack-unit
• show mac-address-table
• show mac-address-table aging-time
• show mac accounting destination
• show mac cam
To Next Page