Dell Force10 TeraScale E Series - Page 876

876 | Layer 2
www.dell.com | support.dell.com
show cam mac linecard (count)
e
Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs.
Syntax
show cam mac linecard slot port-set port-pipe count [vlan vlan-id] [interface interface]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
show cam maccheck linecard
c
Display the results of the BCMI2 check command.
Syntax
show cam maccheck linecard slot port-set port-pipe
Parameters
linecard slot (REQUIRED) Enter the keyword linecard followed by a slot number to
select the linecard for which to gather information.
E-Series range: 0 to 6.
port-set port-pipe (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number
to select the Port-Pipe for which to gather information.
E-Series range: 0 or 1
count (REQUIRED) Enter the keyword count to display CAM usage by interface
type.
interface interface (OPTIONAL) Enter the keyword interface followed by the interface type,
slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display
the MAC address assigned to the VLAN.
Range: 1 to 4094.
pre-Version 6.2.1.1 Introduced on E-Series
linecard slot (REQUIRED) Enter the keyword linecard followed by a slot number to
select the linecard for which to gather information.
C300 range: 0 to 7; C150 range: 0 to 4
port-set port-pipe (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number
to select the Port-Pipe for which to gather information.
Range: 0 or 1