Dell Force10 TeraScale E Series - Page 875

Layer 2 | 875
mac learning-limit station-move-violation
c e s
Specify the actions for a station move violation.
Syntax
mac learning-limit station-move-violation {log | shutdown-both | shutdown-offending |
shutdown-original}
To disable a configuration, use the no mac learning-limit station-move-violation command,
followed by the configured keyword.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Usage
Information
This is supported on physical interfaces, static LAGs, and LACP LAGs.
Related
Commands
mac learning-limit reset
c e s
Reset the MAC address learning-limit error-disabled state.
Syntax
mac learning-limit reset
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
log Enter the keyword log to generate a syslog message on a station move
violation.
shutdown-both Enter the keyword shutdown to shut down both the original and
offending interface and generate a syslog message.
shutdown-offending Enter the keyword shutdown-offending to shut down the offending
interface and generate a syslog message.
shutdown-original Enter the keyword shutdown-original to shut down the original
interface and generate a syslog message.
Version 8.2.1.0 Introduced on S-Series
Version 7.8.1.0 Introduced on C-Series
Version 7.5.1.0 Introduced on E-Series
show mac learning-limit Display details of the mac learning-limit
Version 8.2.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.5.1.0 Introduced on E-Series