Dell Force10 TeraScale E Series - Buffer Tuning Commands

S-Series Debugging and Diagnostics | 1577
online stack-unit
s
Place a stack unit in the online state.
Syntax
online stack-unit number
Parameters
Defaults
None
Command Mode
EXEC Privilege
Command
History
H
Related
Commands
Buffer Tuning Commands
The buffer tuning commands are:
• buffer (Buffer Profile)
• buffer (Configuration)
• buffer-profile (Configuration)
• buffer-profile (Interface)
• show buffer-profile
• show buffer-profile interface
buffer (Buffer Profile)
c s
Allocate an amount of dedicated buffer space, dynamic buffer space, or packet pointers to queues 0 to
3.
Syntax
buffer [dedicated | dynamic | packets-pointers] queue0 number queue1 number queue2
number queue3 number
Parameters
number
Enter the stack unit number.
Range: 0 to 7
Version 7.7.1.0 Introduced on S-Series
show environment (S-Series) View S-Series system component status (for example, temperature, voltage).
Warning: Altering the buffer allocations is a sensitive operation. Do not use any
buffer tuning commands without first contacting the Dell Force10 Technical
Assistance Center.
dedicated
Enter this keyword to configure the amount of dedicated buffer space per
queue.
dynamic
Enter this keyword to configure the amount of dynamic buffer space per
Field Processor.
packets-pointers
Enter this keyword to configure the number of packet pointers per queue.