Dell Force10 TeraScale E Series - IPv6 ACL Commands

684 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
IPv6 ACL Commands
The following commands configure IPv6 ACLs:
• cam-acl
• clear counters ipv6 access-group
• deny
• deny icmp
• deny tcp
• deny udp
• ipv6 access-group
• ipv6 access-list
• permit
• permit icmp
• permit tcp
• permit udp
• remark
• resequence access-list
• resequence prefix-list ipv6
• seq
• show cam-acl
• show config
• show ipv6 accounting access-list
• show running-config acl
• test cam-usage
cam-acl
c e s
Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10}
Parameters
default
Use the default CAM profile settings, and set the CAM as follows.
L3 ACL (ipv4acl): 6
L2 ACL(l2acl): 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl 1-10
ipv6acl 0-10 ipv4qos 1-10
l2qos 1-10
Allocate space to support IPv6 ACLs. You must enter all of the
profiles and a range.
Enter the CAM profile name followed by the amount to be allotted.
The total space allocated must equal 13.
The
ipv6acl range must be a factor of 2.