IPv6 Access Control Lists (IPv6 ACLs) | 685
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be
reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
clear counters ipv6 access-group
c e s
Erase all counters maintained for the IPv6 access lists.
Syntax
clear counters ipv6 access-group [access-list-name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series
access-list-name
(OPTIONAL) Enter the name of a configured access-list, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Introduced on the C-Series
Version 7.4.1.0 Introduced on the E-Series TeraScale
Added
monitor option
To Next Page
Loading...
