Dell Force10 TeraScale E Series - E-Series Debugging and Diagnostics; Overview; Diagnostics and Monitoring Commands

E-Series Debugging and Diagnostics | 1535
65
E-Series Debugging and Diagnostics
Overview
FTOS supports an extensive suite of protocol-specific debug commands for packet- and event-level
debugging. These commands are described throughout this document. In addition, FTOS supports
commands for diagnosing suspected hardware issues.
This chapter contains the following sections:
• Diagnostics and Monitoring Commands
• Offline Diagnostic Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The diagnostics and monitoring commands are:
• dataplane-diag disable loopback
• dataplane-diag disable sfm-bringdown
• dataplane-diag disable sfm-walk
• dataplane-diag disable dfo-reporting
• diag linecard
• diag sfm
• ip control-plane egress-filter-traffic
• ipv6 control-plane egress-filter-traffic
• logging coredump kernel disable
• logging coredump kernel server
• logging coredump linecard
• power-off/on sfm
• reset linecard
• reset sfm
• show command-history
• show console
• show diag sfm
• show processes ipc
• show processes ipc
• show processes ipc flow-control
• show revision