Dell Force10 TeraScale E Series - Hardware Commands

1582 | S-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Example
Figure 66-2. show buffer-profile interface Command Example
Related
Commands
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
The commands are:
• clear hardware system-flow
• clear hardware system-flow
• hardware watchdog
• show hardware layer2 acl
• show hardware layer3
• show hardware stack-unit
• show hardware system-flow
clear hardware stack-unit
s
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit 0–7 {counters | unit 0–1 counters | cpu data-plane statistics |
cpu party-bus statistics | stack-port 0–52}
Parameters
FTOS#show buffer-profile detail csf linecard 4 port-set 0
Linecard 4 Port-set 0
Buffer-profile test
Queue# Dedicated Buffer Buffer Packets
(Bytes)
0 36960 718
1 18560 358
2 18560 358
3 18560 358
4 9600 64
5 9600 64
6 9600 64
7 9600 63
FTOS#
buffer-profile (Configuration)
Create a buffer profile that can be applied to an interface.
stack-unit 0-7 Enter the keyword stack-unit followed by 0 to 7 to select a particular
stack member and then enter one of the following command options
to clear a specific collection of data.
counters Enter the keyword counters to clear the counters on the selected stack
member.
unit 0–1 counters Enter the keyword unit along with a port-pipe number, from 0 to 1,
followed by the keyword counters to clear the counters on the selected
port-pipe.
Note: S25 models (S25N, S25P, S25V, etc.) have only port-pipe 0.