1584 | S-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Syntax
hardware watchdog
Defaults
Enabled
Command Mode
CONFIGURATION
Command
History
Usage
Information
This command enables a hardware watchdog mechanism that automatically reboots an FTOS switch/
router with a single unresponsive unit. This is a last resort mechanism intended to prevent a manual
power cycle.
show hardware layer2 acl
s
Display Layer 2 ACL data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer2 acl stack-unit 0-7 port-set 0-1
Parameters
Defaults
No default behavior
Command Modes
EXEC Privilege
Command
History
show hardware layer3
s
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {acl | qos} stack-unit 0-7 port-set 0-1
Parameters
Defaults
No default behavior
Command Modes
EXEC Privilege
Command
History
Version 7.8.1.0 Introduced
stack-unit 0-7 Enter the keyword stack-unit followed by 0 to 7 to select a stack ID.
port-set 0-1 Enter the keyword port-set with a port-pipe number — 0 or 1. The S25 models of
the S-Series have only port-pipe 0.
Version 7.8.1.0 Introduced on S-Series
acl | qos Enter either the keyword acl or the keyword qos to select between
ACL or QoS data.
stack-unit 0-7 Enter the keyword stack-unit followed by a numeral from 0 to 7 to
select a stack ID.
port-set 0-1 Enter the keyword port-set with a port-pipe number — 0 or 1. The S25
models of the S-Series have only port-pipe 0.
Version 7.8.1.0 Introduced on S-Series
To Next Page
Loading...
