Dell Force10 TeraScale E Series - Interface Troubleshooting Commands

1506 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
Example 1
Figure 64-8. show hardware linecard Command Example
Example 2
Figure 64-9. show hardware rpm Command Example
Usage
Information
Interface Troubleshooting Commands
This command provides additional information related to standard show interface commands.
See also in Chapter 23, Interfaces”:
• show interfaces phy
• show interfaces transceiver
FTOS#show hardware linecard 1 cpu data-plane statistics
-----SOCEND driver statistics for device 4-----
rxHandle :0
noBuff :0
noMblk :0
noClblk :0
recvd :0
dropped :0
recvToMux :0
txInt :0
transmitted :0
txRequested :0
noTxDesc :0
txError :0
txWrongIntf :0
txNotInit :0
txReqTooLarge :0
txInternalError :0
rxError :0
Socend Driver Pool Statistics for device 4
-----------------------------------------
poolMBlkGetCnt = 0
poolMClGetCnt = 0
poolClBlkGetCnt = 0
poolClusterGetCnt = 0
poolMBlkFreeCnt = 0
poolMBlkClFreeCnt = 0
poolClBlkFreeCnt = 0
poolClFreeCnt = 0
poolClPoolIdGetCnt = 1
-----------------------------------------
FTOS#show hardware rpm 0 cpu data-plane statistics
-----SOCEND driver statistics for device 2-----
rxHandle :0
noBuff :0
noMblk :0
noClblk :0
recvd :0
dropped :0
recvToMux :0
txInt :0
transmitted :0
txRequested :0
noTxDesc :0
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.