Dell Force10 TeraScale E Series - Access Control Lists (ACL); Overview; Commands Common to all ACL Types

Access Control Lists (ACL) | 205
9
Access Control Lists (ACL)
Overview
Access Control Lists (ACLs) are supported on platforms c e s
FTOS supports the following types of Access Control List (ACL), IP prefix list, and route map:
• Commands Common to all ACL Types
• Common IP ACL Commands
• Standard IP ACL Commands
• Extended IP ACL Commands
• Common MAC Access List Commands
• Standard MAC ACL Commands
• Extended MAC ACL Commands
• IP Prefix List Commands
• Route Map Commands
• AS-Path Commands
• IP Community List Commands
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options.
Some commands may use similar names, but require different options to support the different ACL
types (for example, deny).
• description
• remark
• show config
Note: For ACL commands used in the Trace function, see the section Trace List Commands
in the chapter Security.
Note: For IPv6 ACL commands, see Chapter 25, IPv6 Access Control Lists (IPv6 ACLs).