Dell Force10 TeraScale E Series - Page 206

206 | Access Control Lists (ACL)
www.dell.com | support.dell.com
description
c e s
Configure a short text string describing the ACL.
Syntax
description text
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
remark
c e s
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Usage
Information
The remark command is available in each ACL mode. You can configure up to 4294967290 remarks
in a given ACL.
text
Enter a text string up to 80 characters long.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
remark-number
Enter the remark number. Note that the same sequence number can be used
for the remark and an ACL rule.
Range: 0 to 4294967290
description
Enter a description of up to 80 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.4.1.0 Introduced for E-Series