Dell Force10 TeraScale E Series - Page 866

866 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
Example 1
Figure 29-1. show lacp port-channel-number command
Example 2
Figure 29-2. show lacp sys-id command Example
Example 3
Figure 29-3. show lacp counter command Example
Related
Commands
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced
FTOS#show lacp 1
Port-channel 1 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled,
M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state,
P - Receiver is not in expired state
Port Gi 10/6 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1 Priority 128
Oper: State ACEGIKNP Key 1 Priority 128
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State BCEGIKNP Key 1 Priority 128
FTOS#
FTOS#show lacp 1 sys-id
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
FTOS#
FTOS#show lacp 1 counters
----------------------------------------------------------------------
LACP PDU Marker PDU Unknown Illegal
Port Xmit Recv Xmit Recv Pkts Rx Pkts Rx
----------------------------------------------------------------------
Gi 10/6 200 200 0 0 0 0
FTOS#
clear lacp counters Clear the LACP counters.
show interfaces port-channel Display information on configured Port Channel groups.