Dell Force10 TeraScale E Series - Page 868

868 | Layer 2
www.dell.com | support.dell.com
• show mac learning-limit
clear mac-address-table dynamic
c e s
Clear the MAC address table of all MAC address learned dynamically.
Syntax
clear mac-address-table dynamic {address mac-address | all | interface interface | vlan
vlan-id}
Parameters
Command Modes
EXEC Privilege
Command
History
mac accounting destination
e
Configure a destination counter for Layer 2 traffic.
Syntax
mac accounting destination {mac-address vlan vlan-id | vlan} [bytes | packets]
To delete a destination counter, enter no mac accounting destination.
Parameters
address mac-address Enter the keyword address followed by a MAC address in
nn:nn:nn:nn:nn:nn format.
all Enter the keyword all to delete all MAC address entries in the MAC address
table.
interface interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID number from 1 to 4094.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
mac-address
Enter the MAC address in the nn:nn:nn:nn:nn:nn format to count Layer 2 packets
or bytes sent to that MAC address.
vlan vlan-id Enter the keyword vlan followed by the VLAN ID to count Layer 2 packets or
bytes sent to the VLAN.
Range: 1 to 4094.
bytes (OPTIONAL) Enter the keyword bytes to count only bytes
packets (OPTIONAL) Enter the keyword packets to count only packets.