Layer 2 | 871
Usage
Information
For information on the specific trap sent and the corresponding Syslog refer to Appendix , .
mac-address-table station-move time-interval
e
Reduce the amount of time FTOS takes to detect aged entries and station moves.
Syntax
[no] mac-address-table station-move time-interval number
Parameters
Defaults
5000ms
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS takes 4 to 5 seconds to detect aged entries and station moves because the MAC address table
scanning routine runs every 5000 ms by default. To achieve faster detection, reduce the scanning
interval.
mac-address-table station-move refresh-arp
c e s
Ensure that ARP refreshes the egress interface when a station move occurs due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Usage
Information
See the “NIC Teaming” section of the Layer 2 chapter in the FTOS Configuration Guide for details on
using this command.
time-interval number
Select the interval of the successive scans of the MAC address table that are
used to detect a aged entries and station moves.
Range: 500 to 5000ms
Version 7.8.1.0 Introduced on E-Series
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
To Next Page
Loading...
