Dell Force10 TeraScale E Series - Page 1096

1096 | PIM-Dense Mode (PIM-DM)
www.dell.com | support.dell.com
ip pim dense-mode
c e s
Enable PIM Dense-Mode (PIM-DM) Multicast capability for the specified interface.
Syntax
ip pim dense-mode
To disable PIM-DM, use the no ip pim dense-mode command.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Example
Figure 40-1. ip pim dense-mode Command Example
Usage
Information
Currently, the chassis operates in either PIM Dense-Mode or PIM Sparse-Mode. The mode
configuration for the first PIM enabled interface determines the mode for the entire chassis.
Subsequent configurations, on other interfaces, to enable PIM is only accepted if the mode is the same
as the original configuration mode. The chassis PIM mode can be changed if PIM-configuration from
all interfaces are removed prior to applying a new PIM mode configuration.
Related
Commands
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 8.1.1.0 Introduced on the E-Series ExaScale
Version 6.5.1.0 Introduced
FTOS#conf
FTOS(conf)# interface gigabitethernet 3/27
FTOS(gigabitethernet 3/27)# ip address 10.1.1.1 /24
FTOS(gigabitethernet 3/27)# no shut
FTOS(gigabitethernet 3/27)# ip pim dense-mode
FTOS#
ip pim sparse-mode Configure sparse-mode
show ip pim tib Display PIM tree information.