1100 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Command
History
ip pim bsr-border
c e s
Define the border of PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
Syntax
ip pim bsr-border
To return to the default value, enter no ip pim bsr-border.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
This command is applied to the subsequent PIM-BSR. Existing BSR advertisements are cleaned up by
time out. Candidate RP advertisements can be cleaned using the clear ip pim rp-mapping command.
ip pim bsr-candidate
c e s
Configure the PIM router to join the Bootstrap election process.
Syntax
ip pim bsr-candidate interface [hash-mask-length] [priority]
To return to the default value, enter no ip pim bsr-candidate.
Parameters
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number
from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length.
Range: zero (0) to 32
Default: 30
priority
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: zero (0)
To Next Page