Dell Force10 TeraScale E Series - Page 68

68 | BOOT_USER Mode
www.dell.com | support.dell.com
Parameters
Defaults
full duplex; auto-negotiation
Command Modes
BOOT_USER
Usage
Information
This command is only available in Boot Flash version 2.0.0.21 and higher.
Related
Commands
reload
c es
Exit from this mode and reload FTOS.
Syntax
reload
Command Modes
BOOT_USER
Command
History
Related
Commands
rename
c e
Rename a file.
Syntax
rename file-url
half-duplex Enter the keyword half-duplex to set the Management interface to half-duplex
mode.
full-duplex Enter the keyword full-duplex to set the Management interface to full-duplex
mode.
10m Enter the keyword 10m to set the speed on the Management interface to 10 Mb/
s.
100m Enter the keyword 100m to set the speed of the Management interface to 100
Mb/s.
auto-negotiation Enter the keyword auto-negotiation to enable negotiation on the
Management interface.
no auto-negotiation Enter the keyword no auto-negotiation to disable auto-negotiation on the
Management interface.
show Enter the keyword show to display the settings on the Management interface.
show default-gateway
Display the IP address configured for the default
gateway.
show interface management ethernet
Display the IP address configured for the Management
interface.
Version 7.8.1.0 Introduced on S-Series
save
Save configurations created in BOOT_USER mode (BLI).